Hans Grohe Axor 35116801 Manual de usuario

Installation Instructions / WarrantySteel35115801Steel35116801

10Model 35116801 only:Measure the distance between the wall surface and the end of the handle (x).If x is between 3 1/4” and 3 7/8”, select the “A” sl

11Push the sleeve / handle escutcheon assembly into place over the handle (1). Tighten it by rotating it clockwise (2).Push the flange over the handl

12Measure the distance from the rough to the outside surface of the finished wall (X) (1). Add 1 3/16” to X. Cut the spout connecting thread so that

1335115801User InstructionsPivot the handle up to turn the water on, down to turn it off.Pivot the handle to the left for warmer water, to the right f

14Replacement Parts351168011 flange 969088002 handle 350948003 handle escutcheon 969128004 spout escutcheon 969138005 baseplate 969278006 c

15Limited Lifetime Consumer WarrantyThis product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”).

Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004Tel. 770 360-9880 • Fax 770 360 9887www.hansgrohe-USA.comUS - Installation Instr

2Wall Mounted Single-Handle Lav Set with Base Plate 35115801Wall Mounted Single-Handle Lav Set 3511680135115801 35116801Technical DataMax. flow

3Installation with 38111181 rough manufactured before 03/2004Turn the water off at the supply before beginning this installation.Remove the covers fro

4Install the new cup washers and springs in the rough. Install the cartridge assembly.Installation with 38111181 rough manufactured after 04/2004Remo

5Install the cartridge and anti-twist device in the housing.Install the cup washers and springs in the rough. Install the cartridge assembly.Installa

6Model 35115801 only:Measure the distance between the wall surface and the end of the handle (x).If x is between 3 1/4” and 3 7/8”, select the two “A”

7Connect the fixation nuts to the sleeves.Measure the distance from the rough to the outside surface of the finished wall (X) (1). Add 1 3/16” to X.

8Tighten the retaining nuts with the service key.Lightly lubricate the o-rings on the spout and handle escutcheons with the enclosed lubricant (1). P

9Push the spout over the connecting thread (1). Tighten the set screw with a 3 mm Allen wrench (2). Install the handle flange (3).1.2.3.